Error messages
156
Operating Manual XCx 300 / 500 / 540 Version 09/08
0x02200009 Achse nicht referenziert
(Achse n)
[Axis not referenced
(Axis n)]
A program can only be started after all its
axes have been synchronized. If axes do not
need to be homed, e.g. rotary axes/spindles
set Q.52 bit 3 = 1 to tell the program that the
axis has been synchronized.
0x0220000A Repositionieren
(Achse n)
[Repositioning
(Axis n)]
0x0220000B SERCOS-Zykluszeit zu klein
(Achse n)
[SERCOS cycle time too short
(Axis n)]
The set cycle time for SERCOS is too short.
0x0220000C Fehler beim Nachführbetrieb
(Achse n)
[Error in follow-up operation
(Axis n)]
A non-programmed follow-up operation was
executed during the CNC program.
0x0220000D Sollwertfehler
(Achse n)
[Set value error
(Axis n)]
0x0220000E Gewindefehler
(Achse n)
[Thread error
(Axis n)]
0x0220000F Watchdog Antriebsmodul
(Achse n)
[Drive module watchdog
(Axis n)]
0x02200010 PCI-Basisadresse ungültig
(Achse n)
[PCI base address invalid
(Axis n)]
Only on ProNumeric / PN-MIC
0x02200011 Falsche Modul-Nummer
(Achse n)
[Incorrect module number
(Axis n)]
0x02200012 Falsche Kanal-Nummer
(Achse n)
[Incorrect channel number
(Axis n)]
0x02200013 Kartenkennung ungültig
(Achse n)
[Card ID invalid
(Axis n)]
0x02200014 Drehzahlsollwert zu groß
(Achse n)
[Desired rotary speed too high
(Axis n)]