Safety-related Information
8
Operating Manual XCx 300 / 500 / 540 Version 09/08
1
Safety-related Information
The term automation system as used in this manual includes control
units, their components (modules), other parts (such as racks, cables),
operator panels, and the software used for programming,
commissioning and operating the control units. This operating manual
can only describe a fraction of the automation system (e.g. modules).
The technical design of SCHLEICHER automation systems is based
on the EN 61131-2 (IEC 61131-2) product norm. The systems and
devices have CE marking according to the EMC directive 89/336/EEC
and, if applicable, the low-voltage directive 73/23/EEC.
The machinery directive 89/392/EEC is not applicable, because the
safety objectives of the directive are covered by the low-voltage and
EMC directives.
When SCHLEICHER automation systems are part of the electrical
equipment of a machine, the manufacturer must include them in the
conformity evaluation process. In this case the DIN EN 60204-1 norm
must be observed (safety of machines, general requirements for
electrical equipment of machines).
When an automation system is properly maintained and used for its
intended purpose it will not normally cause damage to property or
present health hazards. However, improper configuration, installation,
maintenance or operation of the system or machine, ignoring the
instructions in this manual, or intervention by insufficiently qualified
personnel may result in connected actuators (such as motors,
hydraulic units, etc.) becoming a source of danger.
1.1
Correct Use of the System
SCHLEICHER automation systems are state-of-the-art products and
manufactured to recognised safety requirements. All the same, their
use can cause danger to the health and safety of operators and others,
or damage machines, systems or other property.
The automation system must only be used in perfect technical
condition for its intended purpose, with attention given to safety and
danger, and observing the operating manual. Correct transport,
storage, installation, operation and maintenance of the system are all
prerequisites for smooth and safe operation of the control system.
Malfunctions, in particular those which may affect safety, must be
immediately resolved.
Automation systems are designed exclusively to control machines and
systems. Automation systems are not intended for any other use than
the above. The manufacturer will therefore accept no liability for any
damages resulting from the incorrect use of the systems.
When using automation systems, all instructions given in this manual
regarding mechanical and electrical setup, commissioning and operation
must be observed.