10. Humidity
The humidity sensor on the SST-W100 is located on the PCB board. This humidity sensor monitors the
humidity in the room and its settings determine when to turn on humidifiers and dehumidifiers as well as
whether the Humidity Control Logic (HCL) built into the thermostat will extend a cool call.
Displaying Humidity
By default, the SST-W100 is set up to display the humidity of the room in the top right corner of the LCD
display. If the system is in energy saver mode, press any button twice and the main configuration screen will
open. Refer to the
above for location on LCD that the humidity is displayed.
Adjusting Humidity Setpoint
To adjust the Humidity setpoint, do the following:
1.
From the main window setup screen, press the
MENU
button to open the
Menu Selection
screen.
2. Scroll down and
Select
the
Humidity Settings
option.
3. Scroll down to the
RH Setpoint
option. Increase or decrease the
RH Setpoint
by pressing the
+/-
buttons to the desired humidity setpoint.
Humidity Monitoring Icon
To eliminate the humidity from being displayed on the front LCD display main configuration screen, do the
following:
1.
From the main window setup screen, press the
MENU
button to open the
Menu Selection
screen.
2. Open the
Installer Settings
menu by pressing the two middle buttons simultaneously for 3 seconds.
3. In the I
nstaller Settings
window, scroll down and
Select
the
Humidity Settings
option.
4. Scroll to the
RH Display
option. Using the
+/-
buttons, change the settings to
O
ff
.
5. Select
Done
.
6. Continue to press the
Done
button to revert back to the main thermostat control screen. Verify the
humidity is no longer displayed.
SST-W100 Wireless Thermostat Deployment Guide
Copyright © 2016 Savant Systems, LLC
009-0802-08 | 160225
28 of 50
