sauter equitherm EQJW126F001, Монтаж и эксплуатация

Страница: 70 / 110

56
BA_EQJW126F001_EN001
Electrical connection
Functions WE Configuration
Meter bus 0 CO6 -> F10 - 1
255 Meter bus address for WMZ 1 to 6 (ST.-NR) / 0 to 255
1434 Model code WMZ 1 to 6 / 1434, CAL3, APAtO, SLS
24h Reading mode WMZ 1 to 6 / 24h, CONT, CoiL
Tariff function option HT/NT, only selectable for WMZ1
on setting “1434” and “CONT”:
tAr-A: Function not active
tAr-E: Depending on the following programmable time
schedule, the consumption data are assigned to a
high
tariff or a low tariff. Three time periods can be entered
per day of the week (not vacations or public
holidays):
1–7 daily, 1 = Monday, 2 = Tuesday, ..., 7 = Sunday
8.4.2 Flow rate and/or capacity limitation using meter bus
The refreshing rate of the measured variable (flow rate and/or capacity) must
be less than fives seconds to ensure that the limitation can be performed
properly. The techni- cal documentation TV-SK 6311 lists the heat meters which
comply with this criterion and, therefore can be used for limitation. Note that
some makes, particularly bat- tery-operated heat meters, respond with
communication pauses when they are read too frequently. Others might run out
of energy early. For details, refer to TV-SK 6311.
Flow rate limitation
All function block parameters required to set up flow rate limitation are available in
CO6 -> F11. The systems's Max. limit value have to be set. The Limiting factor
determines how strongly the controller responds when the limit values are
exceeded in either direc- tion. In extended operating level, the data point Flow
rate [m³/h] in conjunction with square 1 at the top display indicates that the flow
rate limitation is active. Press the ro- tary pushbutton to display the current max.
limit value.
Note: If CO5 -> F00 - 1 is indicated, access to the return flow, flow rate and heat
capac- ity settings are locked
Functions WE Configuration
Meter bus 0 CO6 -> F10 - 1
255 Meter bus address WMZ 1 to 6 (ST.-NR) / 0 to 255