Sanyo Denki Sanmotion R 3E S, Инструкция по эксплуатации

Страница: 326 / 514

7. Digital Operator
7-19
7.10 Velocity-controlled JOG Operation
■
For stopping during operation, please push the MODE button.
■
Display below is state of over travel.
✔
Over-travel functions are set at general parameter Group9 ID00 “Positive Over Travel
Function[F-OT]”, ID01 “Negative Over Travel Function [R-OT]”.
See detail in "5.8 Parameter functions", Group9 "Function enabling condition settings".
Step
Displayed
character,
number, code
Input button How to operate
1 Push MODE until it displays the left.
2 Display changes and right end LED blinks.
3
Make as the left display with addition and
subtraction and the cursor button.
4 Push WR for more than 1 second.
5 Changes to the left display.
6 Push WR for more than 1 second.
7 The character of 8 is drawn and servo is on.
8
If it continues pushing an addition button, a motor
shaft will rotate in the CCW direction. Will stop when
an addition button is detached.
9
If it continues pushing an addition button, a motor
shaft will rotate in the CW direction. Will stop when a
subtraction button is detached.
10 Push MODE.
11 Servo is off and it changes to the left display.
12 Push MODE.
13 Completes and changes to the left display.
MODE is pushed in Process 2.
Changes to the left display and shifts to system parameter.
MODE is pushed in Process 5.
Changes to the left display and returns to step 2.
MODE is pushed in Process 7.
Changes to the left display and returns to step 5.
Mode is pushed again.
Completes and changes to the left display.
Positive direction over-travel status.
Positive direction over-travel has occurred at position/velocity control.
Negative direction over-travel status.
Negative direction over-travel has occurred at position/velocity control.
MODE
▲ ▼
WR/
MODE
▲ ▼
WR/
MODE
▲
▼
WR/
MODE
▲
▼
WR/
MODE
▲
▼
WR/
MODE
▲ ▼
WR/
MODE
▲ ▼
WR/
MODE
▲
▼
WR/