Sanyo Denki Sanmotion R 3E S, Инструкция по эксплуатации

Страница: 255 / 514

5.8 Parameter functions
5-132
5
O
per
ation
－ GroupD －
ID Contents
20
Drec. sampling rate
[SAMPDIV]
Setting range Unit Default value
0 to 65535 - 20
■
Sets the sampling rate of the Drive recorder.
 Minimum sampling rate (Ts) is fixed to 112 μ s.

Sampling timing (T) is shown by T=Ts*n, and this parameter sets "n".
 Drive recorder will stop if 0 is set.
21
Drec. sampling mode
[SAMPNUM] Setting range Unit Default value
00 to 02 - 00:256point
■
Selects total data points per channel that will record by the Drive recorder.
 Recordable channel numbers will limit if larger data point is selected.
22
Drec. Trigger Channel
[TRGCHSEL] Setting range Unit Default value
00 to 83 - 83:DIGITAL_4
■
Selects the channel for trigger on the Drive recorder.
 Digital ch. and analog ch. can set.
23
Drec. Trigger Slope
[TRGEDGSEL] Setting range Unit Default value
00 to 02 - 00:POS_EDGE
■
Sets the trigger edge condition on the Drive recorder.
24
Drec. Trigger Horizontal Position
[TRGHPOS]
Setting range Unit Default value
0 to 100 % 80
■
Sets the horizontal position of trigger on the Drive recorder.
 Set the rate of the total sampling time and the trigger position from sampling start by
[0 -100%].
25
Drec. Trigger Level
[TRGLVL]
Setting range Unit Default value
-9223372036854775808
to
9223372036854775807
- 1
■
Set the trigger level on the Drive recorder.
 Shows by hexadecimal (32 bit data) at ID25 and ID26 of the Digital operator.
Selection Maximum recordable channel at once
00 256point 6 channels
01 512point 3 channels
02 1024point 1 channel
ID Data range Display range
25 Bit63 to Bit32 H.8000 L.0000 to H.7FFF L.FFFF
26 Bit31 to Bit0 H.0000 L.0000 to H.FFFF L.FFFF
Selection Setting value Selection Setting value
00 ANALOG_1 Analog CH1 05 ANALOG_6 Analog CH6
01 ANALOG_2 Analog CH2 80 DIGITAL_1 Digital CH1
02 ANALOG_3 Analog CH3 81 DIGITAL_2 Digital CH2
03 ANALOG_4 Analog CH4 82 DIGITAL_3 Digital CH3
04 ANALOG_5 Analog CH5 83 DIGITAL_4 Digital CH4
Selection Setting value
00 POS_EDGE
↑
edge
01 NEG_EDGE
↓ edge
02 BOTH_EDGE
↑
edge or
↓
edge