Samson 3730-4, Руководство по настройке

Страница: 33 / 100

Octet Bit Explanation Note
18 3) 0 No emergency mode (see Code 76)
1 Program load error (see Code 77)
2 Options parameter (see Code 78)
3 Info parameter (see Code 75)
4 Data memory (see Code 66)
5 Control calculation (see Code 67)
6 PA parameter (see Code 74)
7 Diagnostic parameter (see Code 80)
19 3) 0 Reset communication controller
1 Reset SPC4 (reset comm HW interface)
2 Binary input 2 deactivated
3 Reset closed-loop controller
4…7 Not assigned
20 3) 0 Air supply: Perhaps modified (TEST) 2
1 Air supply: Perhaps not enough (TEST) 2
2 Air supply: Perhaps not enough 2
3 Air supply: At full capacity 2
4 Air supply: At full capacity (TEST) 2
5 Air supply: Perhaps modified 2
6 Actuator spring: Stiffness reduced (TEST) 2
7 Actuator spring: Pretensioning reduced (TEST) 2
21 3) 0 Actuator spring: Perhaps pretensioning increased (TEST) 2
1 Actuator spring: Working at full capacity 2
2 Actuator spring: Working at full capacity (TEST) 2
3 Shifting working range: Close 2
4 Shifting working range: Open 2
5 Friction: Higher over whole range 2
6 Friction: Lower over whole range 2
7 Friction: Higher over partial range 2
KH 8384-4 EN
33
Standard diagnostics with PROFIBUS-DP protocol