Samson 3730-4, Руководство по настройке

Страница: 27 / 100

Fault/diagnostic alarm
Default setting acc. to Pro-
file 3.01 Condensed Status
Classified
Diagnosis
Yes No
Perhaps bias reduced (TEST)
0x80 GOOD_NON_SPECIFIC • –
Perhaps bias increased (TEST)
0x80 GOOD_NON_SPECIFIC • –
Working at full capacity
0x80 GOOD_NON_SPECIFIC • –
Working at full capacity (TEST)
0x80 GOOD_NON_SPECIFIC • –
Shifting working range
Shifting working range close position
0x80 GOOD_NON_SPECIFIC • –
Shifting working range max. open
0x80 GOOD_NON_SPECIFIC • –
Friction
Much higher over whole range
0x80 GOOD_NON_SPECIFIC • –
Much lower over whole range
0x80 GOOD_NON_SPECIFIC • –
Much higher over partial range
0x80 GOOD_NON_SPECIFIC • –
Much lower over partial range
0x80 GOOD_NON_SPECIFIC • –
Much higher over whole range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Much lower over whole range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Much higher over partial range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Much lower over partial range (TEST)
0x80 GOOD_NON_SPECIFIC • –
Leakage pneumatics
Perhaps existing (TEST)
0x80 GOOD_NON_SPECIFIC • –
Perhaps existing
0x80 GOOD_NON_SPECIFIC •
–
Perhaps too large (TEST) 0x80 GOOD_NON_SPECIFIC • –
Perhaps too large 0x80 GOOD_NON_SPECIFIC • –
Limit range
Down 0x80 GOOD_NON_SPECIFIC • –
Up 0x80 GOOD_NON_SPECIFIC • –
Modification impossible
0x80 GOOD_NON_SPECIFIC • –
Dynamic stress factor
Load factor > 90 % 0x80 GOOD_NON_SPECIFIC • –
Inner leakage (shut-off)
Perhaps existing 0x80 GOOD_NON_SPECIFIC • –
KH 8384-4 EN
27
Status alarms according to Profile 3.01 Condensed Status