Rohde & Schwarz EX-IQ-BOX, Руководство пользователя

Страница: 32 / 418

System Overview
R&S
®
EX-IQ-BOX
17 User Manual 1409.5570.32 ─ 05
Information on the LAN Connector of the R&S EX-IQ-BOX
Data and settings of the R&S EX-IQ-BOX are controlled via the USB interface. The LAN
connector is intended for future use and it is not possible to directly remote-control the
R&S
EX-IQ-BOX via the LAN interface.
For the control, SCPI ( S tandard C ommands for P rogrammable I nstruments) commands
are used.
An introduction to the structure and to the syntax of SCPI commands is given in the
operating manual of the R&S
EX-IQ-BOX, see
​
chapter 8, "Remote Control Basics" ,
on page 213.
3.1.3.1 Remote Control via R&S DigIConf
The remote control program controls R&S DigIConf, which then transmits the settings to
the R&S EX-IQ-BOX via the USB interface. The remote program runs either on the same
PC as the R&S DigIConf software or on any PC in a network.
Examples of the remote controlled R&S DigIConf
●
The remote control program and R&S DigIConf run on the same computer.
R&S EX-IQ-BOX
USB
LAN
Control
R&S DigIConf
Remote
Adress: Local Host
Port: 5026
Remote control program
Fig. 3-4: Remote control program and R&S DigIConf running on the same PC
The remote connection is looped internally. The computer name, i.e. the IP address
is "Local Host". R&S
DigIConf uses port 5026 by default, the port can be set.
●
The remote control program and R&S DigIConf run on different computers.
Basic Operating Modes