Rohde & Schwarz EX-IQ-BOX, Руководство пользователя

Страница: 309 / 418

Remote Control Commands
R&S
®
EX-IQ-BOX
294 User Manual 1409.5570.32 ─ 05
[:SOURce<hw>]:EBOX:CPRI:CM:HDLC:BRATe <Rate>
The command sets the bit rate for transmission of the control data in slow C&M mode
(HDLC).
Note: The maximum HDLC rate for slow C&M depends on the CPRI Line Bit Rate. The
following table shows the available HDLC bit rates for the corresponding CPRI bit rates.
CPRI Line Bit Rate 2x (1228.8 Mbit/s) 4x(2457.6 Mbit/s) 5x (3072.0 Mbit/s)
Possible HDLC Bit Rates
in kbit/s 240
480
960
240
480
960
1920
240
480
960
1920
2400
Parameters:
<Rate> 240 | 480 | 960 | 1920 | 2400
Range:
240000 to 2400000
Increment: 1
*RST:
240000
Default unit: kbit/s
Example:
SOUR1:EBOX:CPRI:CM:HDLC:BRAT 480
select a bit rate of 480 kbit/s for slow C&M transmission.
Manual operation: See "Bit Rate" on page 195
[:SOURce<hw>]:EBOX:CPRI:CM:HDLC:COMMand <Command>
Enters a control command in slow C&M interactive mode.
Note that the command may perform a number of symbols that is divisible by 2. Odd
values ​​are not accepted.
This command applies to HDLC C&M data source "Terminal", see
​
[:
​
SOURce<hw>]:
​
EBOX:
​
CPRI:
​
CM:
​
HDLC:
​
SOURce
​
. In direct mode, that is control data received via the
RS-232-C interface, this command is not effective (CPRI REC Test mode).
Parameters:
<Command> string
Example:
SOUR1:EBOX:CPRI:CM:HDLC:COMM "test cmd"
transmits the test command for slow C&M control to the control
panel.
SOUR1:EBOX:CPRI:CM:HDLC:EXEC
executes the test command.
Manual operation: See "Terminal" on page 197
CPRI Remote Control Commands