Protocol Settings
R&S
®
EX-IQ-BOX
173
User Manual 1409.5570.32 ─ 05
Note:
By default, R&S
DigIConf names the signals
signal_
with an attached
<index>
number. The index number represents the position in the list. In order to assign
a user defined name, enter the name in the field "Signal Name" on the right.
Append
Add a new signal to the list. R&S
DigIConf attaches a signal with default parameter val-
ues, a predetermined name and a name index following the last list entry.
Remote command:
Copy + Append
Create a copy of a selected signal. This function copies the parameter values and assigns
the same name with suffix for distinction. The new signal is added at the end of the list.
Remote command:
Delete
Remove the currently selected signal from the list. The function removes the correspond-
ing AxCs from the list of used AxCs.
Remote command:
Signal State
Activate a selected signal.
Remote command:
Signal Name
Enter or change the signal name.
By default, R&S
DigIConf assigns the name
signal_
with an attached
<index>
num-
ber. The index number represents the position in the list.
Remote command:
Physical Source
Select the signal source for signal transmission to the DUT. The signal comes either from
an R&S instrument via the digital interface of the R&S
EX-IQ-BOX, or the signal is gen-
erated internally or by means of the waveform memory in the R&S
EX-IQ-BOX.
The R&S
EX-IQ-BOX converts the I/Q format of the signal into the CPRI protocol format.
Embedded with additional control information, the link transfers the data to the DUT.
Note:
You can select the signal source if the R&S
EX-IQ-BOX works as transmitter, that
means if it sends a signal to the DUT. That is, if you work in the
RE Test Downlink
or
the
REC Test Uplink
mode. Hence, the parameter is available only in the corresponding
DL or UL tab.
CPRI
Содержание EX-IQ-BOX
Страница 147: ...Protocol Settings R S EX IQ BOX 132 User Manual 1409 5570 32 05 CPRI...
Страница 391: ......
