Rion KL-04, Инструкция по эксплуатации

Страница: 151 / 166

135
Maintenance
Handling the Syringe
The sealed piston of the KL-04 Syringe can easily be damaged as it is made of Tefl on.
Please make sure to follow the instructions below in order to maintain the syringe in op-
timum condition for as long as possible.
- Prior to using the syringe, make sure the sealing area is fully moistened, using
pure water such as distilled water or deionized water, etc., to operate the syringe.
Never carry out a dry run.
- When removing the plunger from the outer syringe, and when re-inserting it, please
be sure to handle it in the same manner as above.
- After measuring, clean the inside of the syringe thoroughly using pure water such
as distilled water or deionized water, etc., (repeat over fi ve full strokes).
- Clean the inside of the syringe every one or two weeks using methods A or B
shown below. (Select the method depending on the type of measuring sample or
the measuring frequency.)
A. Cleaning by detergent or bleach
1. Immerse the syringe in diluted detergent or diluted bleach for approx.
30 minutes.
2. Clean it fully using pure water such as distilled water or deionized water
etc.
B. Cleaning with acid or alkali
1. Immerse the syringe in NaOH (10% concentration) for approx. ten min-
utes.
2. Clean it fully using pure water such as distilled water or deionized wa-
ter.
3. Immerse the syringe in HCl (10% concentration) for approx. ten min-
utes.
4. Clean it fully using pure water such as distilled water or deionized wa-
ter.
- If air bubbles are produced continuously from the piston seal, the syringe needs
to be replaced. Please contact the supplier.
Cleaning main unit
- When cleaning main unit, use neutral detergent and wipe up with soft cloth. Please
make sure not to erase the printings, paintings, and markings when cleaning main
unit.
- The printings, paintings, and marking on the main unit are very important information
for safety operation and serious accidents might be caused if operated without them.