REMEHA Avanta Plus 24s, Инструкция по установке и обслуживанию

Страница: 36 / 153

36
Remeha Avanta Plus
2.9.7 Adjust the boiler according to the system
The operating parameters of the Remeha Avanta Plus have
been factory set to suit most systems. However it is possible
to adjust some of the parameters to enable the Remeha Avan-
ta Plus
to operate more efficiently to match specific system
designs and site conditions. These parameters are split into
two specific sections
1. User level – Parameters
p
1
to p
6
; can be changed by
the user to suit CH and DHW comfort conditions
2. Service level – p17 to dF ; must only be changed by
Broag approved Engineer after consultation with the
system designer.
o
How to change the parameters at user level can be read in the
“User manual” provided and therefore will not be detailed in
this Installation and Service manual.
2.9.8 Changing the parameters at service level (with
access code)
To avoid non authorised adjustments, some parameter settings
can only be changed once the special access code
12 has
been entered. This code may only be used by qualified install-
ers. The following settings can be changed at user and service
level:
Codes in display Description
Setting range and notes
where applicable Factory settings
24c 28c 35c 39c
Can also be changed by users
p 1
T
set
flow 20 - 85°C 75°C
p 2
T
set
DHW 40 - 65°C 55°C
p 3
Boiler regulation
0 = CH
off
and DHW
off
1 = CH
on
and DHW
on
2 = CH
on
and DHW
off
3 = CH
off
and DHW
on
2 1 1 1
p
4 Eco or comfort setting
0 = comfort setting
1 = eco mode*
2 = regulated by controller
2
p
5
Anticipated current
0 = no anticipated current
for thermostat on/off
1 = anticipated current
for thermostat on/off
0
p
6
Display off automatically
0 = display stays off
1 = display stays on
2 = displaylight switches off
automatically after 3 minutes
2