REMEHA Avanta Plus 24s, Инструкция по установке и обслуживанию

Страница: 35 / 153

35
R
o
• If the boiler is set to the economy setting (see par. 2.9.8),
it will not supply a boost to DHW after CH is satisfied. The
display then shows; [1 ; pre-purge stage [6 ; pump run on
after CH [0 ; stand-by mode.
•
If a two channel time clock is fitted and connected to a
combi boiler and the time control for DHW is in the “OFF”
position, the DHW production will be disabled unless the
link between connectors 2 and 3 on the X2 terminal is fitted
(normally factory fitted).
2.9.6 Read out settings
The following settings can be read out in the ‘user menu’:
-
t1
= flow temperature [°C];
- t2 = return temperature [°C];
- t3 = boiler temperature [°C];
- t4 = outside temperature [°C];
- fl = ionisation current [
u
A];
- ñf = fan speed [rpm] ;
LT.AL.W7H.000.046
•
Press the [+] key, until t1 appears and, for example,
68 (68°C), the current flow temperature;
•
Press the [+] key again until t2 appears and, for exam-
ple, 45 (45°C), the current return temperature;
•
Press the [+] key again until t3 appears and, for exam-
ple, 50 (50°C), the current boiler temperature;
•
Press the [+] key again until t4 appears and, for exam-
ple,
18
(18°C), the current outside temperature;
•
Press [+] key again until
f l
appears and e.g.
^0
(6uA),
the present ionisation current;
• Press [+] key again until ñf appears and e.g. 30 (3000
rpm), the present fan speed;
• Press [+] key again and the read-out cycle will start again
with t1 , etc.;
• Press [reset] key to return to the display with the current
operating status.