RDZ WI-SA, Техническое руководство по установке

Страница: 31 / 56

31
A
DDRESS
CONFIGUR
ATION
WI-M1 / WI-S2 / WI-S3 / WI-S4
ADDRESS SETTING
WI-Z
XX
/ WI-U
X ADDRESS SETTING
OFF
1
3
2
4
Bus RJ12
/6 pole
address= 0
Esc
Prg
Esc
Prg
ON
5
6 7
pLan address: 1
UP: increase
DOWN: decrease
ENTER: save & exit
As for the expansion units, the address setting is carried out by means of the dip-switches located on the board.
Proceed as follows:
1) Disconnect the power supply from the WI-XX unit
2) Prepare a UI/PRO terminal with address 0 and connect
it to the central unit by means of an RJ12 cable
3) Power the WI-M1/Sx unit
4) Press Alarm +
Up simultaneously. After a few
seconds, screen 5) will appear
6) To modify the address, all you have to do is use the
Up Down buttons and then press Enter to
confirm.
NB: The address to be allocated to the WI-M1 unit in its
standard operation must be 1 .
Keys
Num Descrizione
1
I/O Board Address
P:01=Wi-M1, P:02=Wi-S2, P:03=Wi-S3
2
Terminal name (cannot be changed)
3
Terminal address
4
Terminal function:
-- : None
Pr: Private
Sh: Shared
Sp: Print (not available)
5
NO: back to the address of terminal Trm1
YES: new configuration is confirmed
2 IU-Pro configured 3 IU-Pro configured
P: 01 P: 02 P: 01 P: 02 P: 03
Wi-M1
(Display Add. 10)
Wi-S2
(Display Add. 11)
Wi-M1
(Display Add. 10)
Wi-S2
(Display Add. 11)
Wi-S3
(Display Add. 12)
3 4 3 4 3 4 3 4 3 4
Trm1
10 Pr
Trm1
-- None
Trm1
10 Pr
Trm1
-- None Trm1 -- None
Trm2 11 Pr Trm2 -- None Trm2 11 Pr Trm2 -- None Trm2 -- None
Trm3 32 Sh Trm3 32 Sh Trm3 12 Pr Trm3 32 Sh Trm3 32 Sh
P:01 Adr Priv/Shared
Trm1 10 Pr
Trm2 11 Pr
Trm3 32 Sh Ok?No
Terminal config
Press ENTER
to continue
8
9
10
1
2
3 4
5