RDZ WI-SA, Техническое руководство по установке

Страница: 29 / 56

29
A
DDRESS
CONFIGUR
ATION
Contrast can be adjusted through button combinations that
allow increasing or reducing it.
These button combinations are:
Prg + Alarm + Up to increase contrast;
Prg + Alarm + Down to reduce contrast.
Press Up Enter Down simultaneously for at least 10
seconds to access the network status display screen shown in
the figure.
The boards whose addresses (1-32) are recognised within the
network, are identified.
In this specific case, the address identification 1 for the WI-M1
board and address 10 for the user interface will be displayed.
C
ONTRAST ADJUSTMENT
D
ISPLAYING THE NETWORK STATUS
Key
No. Description
1
RJ12 connector
2
Error indicator light
3
Smart Key-board transfer LED
4
Start button
start
mod
e 1
2
3
4
The program is transferred, using the programming Smart Key
or a PC with Service Manager software and RS485 connector.
Programming the boards, using the Smart Key
Operations for carrying out the transfer.
1) Disconnect the board power supply.
2) Insert the smart key RJ12 cable
3) Power the cable and wait for the start button (1) to light
up.
4) Ensure that the lit arrow is the one that indicates the transfer
from the smart key pointing outwards (2).
5) Press start (1).
6) A buzzer indicates the end of the transfer.
7) Disconnect the power supply.
When the control unit is powered again, it will start with the
previously uploaded program.
In the event of an error signal, repeat the operations described
above.
┌────────────────────┐
│NetSTAT Term:10 │
│ 1 8 │
│ 9 16 │
│ 17 24 │
│ 25 32 │
│Press Enter to quit │
└────────────────────┘
PROGRAMMING THE CONTROL BOARDS
USER INTERFACE FUNCTIONALITY [UI/E]