RDZ WI-SA, Техническое руководство по установке

Страница: 20 / 56

20
SETTINGS / ZONES
ZONES
CHANGE ZONE, DEHUMIDIFIER AND ROOM SENSOR
SETTINGS
<MT> Zone
──────────────────────
Type: *
Dehumidifier: *
Offset: *
──────────────────────
ZONES \
TY
PE
SETTINGS / ZONES / TYPE
ZONE CONFIGURATION
Change the zone configuration
you can configure the presence of the sensor by means of the system type and
association.
Type:
—: Absent Sensor.
HT: Temperature Sensor
HT/H Temperature and Humidity Sensor
Wi-TT: Temperature - Humidity Sensor with Bus connection.
WI-TC: Temperature - Humidity Sensor with Bus connection.
Wi-IHT: Temperature - Humidity Sensor with Bus connection.
Wi-IHP: Temperature - Humidity Sensor with Bus connection.
Wi-ITA: Temperature - Humidity Sensor with cable.
Wi-ITD: Temperature Sensor with Bus connection.
Function:
Win: Enable only winter sensor functions
Sum+Win: Enable both winter and summer functions
Digital In:
Not used
All. TD: when activated locks both the temperature control that the dehumidification
control.
Pres. T: When activated call in temperature alone (like a thermostat).
Pre. T, D man: when activated make the temperature called (like a thermostat) and
enables the dehumidification with manual sets.
Pre. T + D man: when active call the temperature dehumidification with manual sets.
Alarm T: when active blocks only the temperature control, the dehumidifier continues
with its logic of operation.
Replication: the sensor for that zone is physically installed if the replication item shows
00-value, otherwise there is no sensor, and the values used are the ones detected by
the sensor installed in the zone with the same set value (e.g. replication: 05 values
of the sensor in zone 05).
Hum: enables humidification by zone.
ZONE 1
›››
ZONE 64
<01> TYPE
──────────┬───────────
Name │TYPE ->Sys
ZONE 1 │Wi-IHT -> 1
──────────┴───────────
Operation:Sum+Win
Digital In:Not Used
Reply: 00 Hum:Yes