MSRA configuration
R&S
®
FSWP-B1
43
User Manual 1177.5862.02 ─ 09
This parameter has no effect on the instrument's hardware, on the captured data, or on
data processing. It is simply a manipulation of the final results in which absolute fre-
quency values are displayed. Thus, the x-axis of a spectrum display is shifted by a
constant offset if it shows absolute frequencies. However, if it shows frequencies rela-
tive to the signal's center frequency, it is not shifted.
A frequency offset can be used to correct the display of a signal that is slightly distorted
by the measurement setup, for example.
The allowed values range from -1 THz to 1 THz. The default setting is 0 Hz.
Note:
In MSRA mode, this function is only available for the MSRA primary.
Remote command:
6.5
Trigger settings
Access
: "Overview" > "Trigger"
or
: [TRIG] > "Trigger Config"
Trigger settings determine when the input signal is measured. These settings are only
available for the MSRA primary.
The "Capture Offset", which has a similar function to the trigger offset but is available
for MSRA secondary applications only, is described in
Chapter 6.6, "Data acquisition
External triggers from one of the [TRIGGER INPUT/OUTPUT] connectors on the
R&S
FSWP are configured in a separate tab of the dialog box.
For step-by-step instructions on configuring triggered measurements, see the
R&S
FSWP User Manual.
................................................................................................ 44
...............................................................................................44
Trigger settings