R&S FSMR, Руководство по эксплуатации

Страница: 796 / 955

R&S FSMR
IEC/IEEE-Bus Commands of HP Models 856xE, 8566A/B, 8568A/B and 8594E
1166.3363.12 6.2-21 E-2
Command Known Differences
M3 Default value, range, step size
MKACT Only marker 1 is supported as the active marker.
MKBW Default value
MKPT Step size
MKPX Step size
NRL
OL? Storage of instrument settings:
80 characters are returned as information on the instrument settings.
The contents of the 80 characters returned does not correspond to the original data contents of the 8566A /
8568A family.
OL Readout of instrument settings:
The 80 characters read by means of OL? are accepted as information on the corresponding instrument
settings.
The contents of the 80 characters read does not correspond to the original data contents of the 8566A /
8568A family.
RB Default value, range, step size
RL Default value, step size
RLPOS Adapts the position of the reference level even if the tracking generator normalization is not active.
RQS Supported bits:
1 (Units key pressed)
2 (End of Sweep)
3 (Device error)
4 (Command complete)
5 (Illegal command)
SRCNORM
SRCPWR
SP Default value, range, step size
SS Default value, range, step size
ST Default value, range, step size
STB The status bits are mapped as described with command RQS.
Note:
Bit 2 and 4 are always set in parallel if "Command Complete" or "End of Sweep" are recognized. The
R&S
FSMR cannot distinguish between these conditions. Additionally these bits are not suitable for
synchronization on the end of sweep in continuous sweep operation.
TA Output of 1001 trace points of trace A in O1 or O3 format.
TB Output of 1001 trace points of trace B in O1 or O3 format.
TH Default value
VB Range
VBR Default value