R&S FSMR, Руководство по эксплуатации

Страница: 45 / 955

R&S FSMR Getting Started with the Instrument
1166.3363.12 1.19 E-2
Switching On the Instrument
In order to switch on the R&S FSMR, set the power switch on the rear panel to position I.
Set the R&S FSMR to operating mode by pressing the ON/STANDBY key on the front panel. The
green LED must be illuminated.
Startup Menu and Booting
After switching on the instrument, a message indicating the installed BIOS version (e.g. Analyzer BIOS
Rev. 1.2) appears on the screen for a few seconds.
Subsequently Windows XP is booted first and after that the instrument firmware will boot. As soon as
the boot process is finished the instrument will start measuring. The settings used will be the one that
was active when the instrument was previously switched off, provided no other device configuration than
FACTORY had been selected with STARTUP RECALL in the FILE menu.
Switching Off the R&S FSMR
Switch the ON/STANDBY key on the front panel to standby mode by pressing it once.
The R&S FSMR will write the current instrument settings to disk before performing a Windows XP
shutdown. At the end of the shutdown procedure the power supply will be switched to STANDBY mode.
The yellow LED must be illuminated.
Only when removing the R&S FSMR completely from the AC power source:
Set the power switch at the rear panel to position 0.
Operating the R&S FSMR with the Removable Hard Disk Option R&S FSMR-B18
The R&S FSMR-B18 option allows the instrument to be operated with differently configured hard disks.
Additional hard disks are therefore available as option FSU-B19.
Caution!
Switch off the instrument before you remove and exchange the hard disk. Exchanging
the hard disk during operation can produce severe data errors.