R&S FSMR, Руководство по эксплуатации

Страница: 676 / 955

SENSe:ADEMod - Subsystem R&S FSMR
1313.9723.12 6.1-140 E-1
This command is an event and therefore has no *RST value and no query.
[SENSe:]ADEMod:DETector:AVERage[:STATe] ON | OFF
This command switches on or off the average detector in the modulation summary. The command is
executed independently of the settings for the other detectors.
Example: "
ADEM ON
" 'Switches on the demodulator.
"
CALC2:FEED 'XTIM:FM:TDOM
" 'Switches on the FM modulation summary.
"
ADEM:DET:AVER ON
" 'Switches on the average detector.
Characteristics: *RST value: OFF
SCPI: device-specific
[[SENSe:]ADEMod:DETector:MPEak:MODE ABSolute | RELative
This command switches on absolute or relative measurement for the minus peak detector in the
modulation summary. Each time the relative measurement mode is switched on, the current
measured value is taken as a reference for the subsequent relative measurements. The command is
executed independently of the settings for the other detectors.
Example: "
ADEM:DET:MPE:MODE REL
" 'Switches on the relative measurement
for the minus peak detector.
Characteristics: *RST value: ABS
SCPI: device-specific
[SENSe:]ADEMod:DETector:MPEak:REFerence <numeric_value>
This command sets or queries the reference value for the relative measurement for the minus peak
detector in the modulation summary.
Example: "
ADEM ON
" 'Switches on the demodulator.
"
CALC2:FEED 'XTIM:FM:TDOM'
" 'Switches on the FM modulation summary.
"
ADEM:DET:MPE ON
" 'Switches on the minus peak detector.
"
ADEM:DET:MPE:MODE REL
" 'Switches on the relative measurement
for the minus peak detector.
"
ADEM:DET:MPE:REF 20 kHz
" 'Sets the reference value.
Characteristics: *RST value: 0
SCPI: device-specific
[SENSe:]ADEMod:DETector:MPEak:REFerence:AUTO ONCE
This command uses the current measured value as a reference for the relative measurement for the
minus peak detector in the modulation summary.
Example: "
ADEM:DET:MPE:REF:AUTO ONCE
" 'Uses the current measured value
as a reference for the relative
measurement.
Characteristics: *RST value: -
SCPI: device-specific
This command is an event and therefore has no *RST value and no query.
SENSe:]ADEMod:DETector:MPEak[:STATe] ON | OFF
This command switches on or off the minus peak detector in the modulation summary.
The command is executed independently of the settings for the other detectors.