R&S FSMR, Руководство по эксплуатации

Страница: 430 / 955

R&S FSMR External Generator Control - Configuration
1166.3363.12 4.23-2 E-1
External Generator Settings
The NETWORK hotkey opens the menu for setting the functions of the external generator.
SOURCE
CAL
NETWORK CAL
TRANS
EXT SRC
ON OFF
SELECT
GENERATOR
FREQUENCY
SWEEP
CAL REFL
SHORT
CAL REFL
OPEN
REF VALUE
POSITION
REF VALUE
NORMALIZE
RECALL
EXT
SOURCE
SOURCE
POWER
FREQUENCY
OFFSET
POWER
OFFSET
GEN REF
INT EXT
SAVE AS
TRD FACTOR
SOURCE
POWER
The SOURCE POWER softkey activates the entry of the generator output
level. The value range depends on the selected generator (See table of
chapter "Configuration of the External Generator").
If both option External Generator Control B10 and option Tracking Generator
B9 are installed, the softkey will modify the output power of the generator
currently in use.
The default output power is -20 dBm.
IEC/IEEE-bus command:
SOUR:EXT:POW –20dBm
POWER
OFFSET
The POWER OFFSET softkey activates the entry of a constant level offset
of the generator. With this offset, attenuator pads or amplifiers connected to
the output connector of the generator can be handled during the input and
output of output levels.
The permissible setting range is -200 dB to +200 dB in steps of 0.1 dB.
Positive offsets handle a subsequent amplifier and negative offsets an
attenuator pad.
The default setting is 0 dB; offsets <> 0 are marked by the activated
enhancement label
LVL .
IEC/IEEE-bus command
SOUR:POW:OFFS -10dB