User Manual Version 3.1
29
Figure 15: Control unit
Pos: 37 /Bedienungsanleitungen/Geräte spezifisch/Drucker/AS-Orbit/3.3.6_Ü3_How to connect the AS-Orbit to the production line @ 2\mod_1266246811282_912.doc @ 12120 @ 3
3.4.7
How to connect the
Quadient
AS-Orbit to the production line
Mandatory connection!
The AS-Orbit must be able to start (release) and stop the production
line onto which it is installed.
A connection between the AS-Orbit and the production line must ensure that the production
line can only be started, when the AS-Orbit is ready to print! This is necessary for the
following situations:
•
The AS-Orbit is not ready to print or has no data to print.
•
The AS-Orbit notices an error during printing.
•
The AS-Orbit runs out of ink.
•
The operator pauses the job.
Working without connection to the production line
The consequence could be that products pass under the printer
without begin printed on and that this is not noticed by the operator!
Depending on the existing equipment you can use one of the output interfaces on the rear
side of the control unit. See Figure 16 below for a detailed description for each output.
When using the output interfaces “Relay 1 / 2“, make sure that the menu
RELAY1/2 OUTPUT
is set to
feeder control
.
Содержание AS-Orbit
Страница 1: ...User guide AS Orbit Address Printer ...
Страница 224: ...9204009J C 12 04 2021 ...