quadient AS-Orbit, Руководство пользователя

Страница: 203 / 224

User Manual Version 3.1 203
12 Sample applications
Pos: 136 /Bedienungsanleitungen/Geräte spezifisch/Drucker/AS-Orbit/11.X_Ü2_Sample application_WEB_AS-Orbit @ 2\mod_1271674355743_912.doc @ 16802 @ 2
12.1 AS-Orbit mounted on a web
When using the AS-Orbit in a web application (e.g. paper web in a label printing machine) it
is important to adjust certain printer menus. In this sample application we set the menu for
the application shown in Figure 94.
Menu Setting Description
Printer Configuration >
BOOT DEFAULTS >
TRANSP. DIRECTION L->R
Viewed from the operator side, the
material enters from the left and exits to
the right.
Note that the encoder wheel is rotating in
the correct direction: Counter-clockwise
(viewed from the operator side).
Printer Configuration >
BOOT DEFAULTS >
TRANSPORT ERROR cont. print
The printer will wait during a stop of the
transport system and continue the print
job when it detects a movement again.
Make sure to check all pages underneath
and behind the printer on every stop of
the transport system. The readability of
the printouts could be affected by the stop
of the transport system.
Printer Configuration >
BOOT DEFAULTS >
GAP CHECK Off
As the print mark in the sample is very
narrow (smaller than 9 mm) we turn the
GAP CHECK
off.
Note that the print area must be 5 mm
smaller than the size of each product. For
example your product on the web is 120
mm in transport direction, so you can print
on 115 mm of the product in transport
direction
Printer Configuration >
ERROR HANDLING >
CHECK BELT START Off
The printer will not monitor the transport
movement and will instantly send a
release signal to the output interfaces
(e.g. feeder control) at print start.