Rotor-Gene Q MDx CE User Manual 02/2022
188
Message text
27
There was a problem communicating with the communication board. You should reboot the computer
and then retry.
28
There was a timeout attempting to talk to the instrument. Check it is correctly plugged in.
29
This feature cannot be used in virtual mode.
30
This profile file was created in a more recent version of the Rotor-Gene software. Certain aspects may not
load correctly.
31
This run file was created in a more recent version of the Rotor-Gene software. Certain aspects of the run
may not load correctly.
32
This sample file was created in a more recent version of the Rotor-Gene software. Certain aspects may
not load correctly.
33
This software will perform basic simulation of a machine for training and demonstration purposes. You
can disable this setting via the Setup screen, accessible from the File menu.
34
This template was created in a more recent version of the Rotor-Gene software. Certain aspects of the
template may not load correctly.
35
Unable to load this sample file as tube layouts do not match. Load these samples before starting the run.
36
Unable to open communications with the machine because another application is already using
<COMPORT>. Check you do not have any applications running that use the same serial port, then retry.
37
Unrecoverable errors were encountered while attempting to load the file. The file was not loaded.
38
You cannot stop the program while the run is in progress.
39
You have insufficient rights to use the software. Please contact the domain administrator to set up groups.
40
You must have performed a quantitation analysis to export samples.
41
You must select a COM port before continuing.
42
Your run could not be saved to its default location. On the following window, select an alternative
location to save your run.
43
Your settings have been saved. Click OK to close the software.
44
You must select a rotor before continuing.
45
You cannot start the run until you tick the checkbox to confirm that the locking ring has been attached.
Autogain adjustment messages
46
Manual gain adjustment uses the channels you have defined in your profile. As you have not defined any
acquisition points in your profile, you cannot perform manual gain adjustment.
47
The temperature you entered was not saved because it was outside the range of the machine. Enter a
valid temperature.
Editor messages
48
Please enter a valid group code. Group codes must be a maximum of 5 characters, and contain no
spaces or commas.
49
Please enter a valid group name. Group names cannot contain commas or be empty.
Optical denature calibration messages
50
Unable to set as optical denature point due to calibration failure. Please enter a valid number of seconds
to hold. It should be a positive value.
51
A melt peak could not be detected during Optical Denature Calibration. This may be because the
incorrect tube was selected for calibration, or that an inappropriate chemistry was used for this sample.
A timed step profile was run instead.
OTV messages
52
You must enter a valid OTV serial number to perform the run.
53
This temperature verification file has been corrupted. Please uninstall and re-install the Rotor-Gene
software to correct this error.
54
This run file is not correctly signed. Results cannot be displayed.
55
You cannot start until you tick the checkbox to confirm that the fluorescent insert has been placed
correctly.
56
This rotor has expired. Please contact your distributor to obtain a replacement.
Security menu messages
57
Could not open the Windows user/group manager.