PURSUIT 3000 EXPRESS, Руководство пользователя

Страница: 86 / 160

3000 EXPRESS
The vacuum generator is mounted on the holding tank and contains stored vacuum. System
vacuum is monitored by a vacuum switch which is located on the vacuum generator tank. When
the switch senses a drop in vacuum in the system, it automatically signals the pump to energize
and bring the vacuum back to operating level. This process is normally completed in less than
two minutes.
It is normal for the stored vacuum to leak down slightly between flushes, causing the vacuum
pump to run for a short period. The pump should not run more than once every three hours after
the last flush for recharging the system. A holding tank fluid level monitor and macerator pump
out switch is located in a panel near the toilet. Please refer to the toilet manufacturer owner's
manual for more information on the operation of the marine head system.
Holding Tank and Macerator Discharge Pump
The holding tank and vacuum generator is located in the engine compartment. The macerator
pump is located on the rear engine room bulkhead and accessed by lifting the bridge deck.
When the tank is full, the tank monitor will show full and the vacuum pump will not run. The
tank must either be pumped out by an approved waste dumping station through the waste deck
fitting or be pumped overboard with the macerator discharge pump, when legal to do so.
To operate the macerator discharge pump, open the ball valve at the overboard discharge thru hull
fitting. Then activate the momentary macerator switch located in the holding tank monitor panel
in the head compartment, until the tank is emptied. Release the switch and close the discharge
ball valve when pumping is complete.
Note: The macerator discharge pump can only be run dry for a couple of seconds.
Allowing the macerator pump to run after the holding tank is empty will cause
damage to the pump.
IN MANY AREAS IT IS ILLEGAL TO FLUSH HEAD WASTE DIRECTLY OVER-
BOARD. VIOLATION OF THESE POLLUTION LAWS CAN RESULT IN FINES OR
IMPRISONMENT. ALWAYS KNOW THE LAW FOR THE AREAS IN WHICH YOU
BOAT. NEVER DUMP HEAD OR HOLDING TANK WASTE OVERBOARD ILLE-
GALLY.
Maintenance
The head should be cleaned and inspected for leaks regularly.
The holding tank should be pumped out and flushed as needed. Periodically add chemical to the
head to help control odor and to chemically break down the waste. See the manufacturer owner’s
manual for additional operating and maintenance information.
10-2