PURSUIT 3000 EXPRESS, Руководство пользователя

Страница: 46 / 160

3000 EXPRESS
Cockpit Lights
Activates the lights that illuminate the cockpit area.
Spreader Lights
Activates the flood lights located on the optional radar arch or hardtop. These lights provide
additional lighting for the rear of the cockpit.
Bilge Blower
This switch supplies electrical current to the blower that provides ventilation to the engine
compartment prior to start up and while operating below cruise speed.
GASOLINE VAPORS CAN EXPLODE. BEFORE STARTING THE ENGINES, OPER-
ATE THE ENGINE COMPARTMENT BLOWER FOR FIVE (5) MINUTES, OPEN THE
ENGINE HATCH, INSPECT THE FUEL SYSTEM AND CHECK THE ENGINE COM-
PARTMENT FOR THE ODOR OF GASOLINE VAPORS. ALWAYS OPERATE THE
BLOWER WHILE THE ENGINE IS AT IDLE AND BELOW CRUISE SPEED. UNDER
NO CIRCUMSTANCES SHOULD THIS PROCEDURE BE OVERLOOKED.
Note: Please refer to the DANGER and CAUTION notations in the Ventilation Systems.
Fwd Bilge Pump
Activates the forward bilge pump which is installed in the engine compartment bilge. The
pump moves water out through the thru-hull fitting in the hull. To start the pump
manually, put the switch in the “ON” position.
Aft Bilge Pump
Activates the stern bilge pump which is installed in the rear center of the bilge. The pump
moves water out through the thru-hull fitting in
the hull. To start the pump
manually, put the switch in the “ON” position.
Note: The bilge pumps will start automatically when there is sufficient water in the bilge
to activate the float switches. The float switches are protected by 10-amp circuit
breakers located on the TABS unit and are always supplied current when the
batteries are connected.
Panel Lights
Activates the engine gauge and compass lights.
Wiper
Activates windshield wipers.
4-4