PURSUIT 3000 EXPRESS, Руководство пользователя

Страница: 54 / 160

3000 EXPRESS
Refrigerator
Supplies AC electrical current directly to the optional refrigerator when AC power is available
and chosen over the 12-volt power supply. See the refrigerator manual for more information.
Ice Maker
Supplies AC electrical current directly to the optional ice maker when AC power is available. See
the ice maker manual for more information.
Stove
Supplies electrical current directly to the galley stove.
Battery Charger
Supplies electrical current directly to the automatic battery charger. The battery charger charges
and maintains the 12-volt batteries simultaneously when activated. It is fully automatic and is
equipped with an amp meter to monitor charging. See the battery charger manual for more
information.
Charging also can be monitored by using the volt meters in the engine gauge cluster and the cabin
DC breaker panel. To monitor the engine batteries, activate the charger and turn the engine
battery switches on. Turn the ignition key switch for each engine to the “ON” position (DO NOT
START THE ENGINES) and read the voltage on the volt meter for each engine. To monitor
the house battery, activate the charger and turn the house battery switch on. Read the volt meter
in the cabin DC breaker panel. If the batteries are in good condition and charging properly, the
volt meters will indicate between 12 and 14.5 volts. If the reading is below 12 volts, then the
battery is not accepting a charge or the charger is not working properly. Always turn the ignition
switches off immediately after the monitoring is complete. See the battery charger manual for
more information.
The wires that supply DC charging current to the batteries are protected by an internal fuse in the
battery charger and three external circuit breakers, one for each battery bank output wire, located
near the TABS unit. The external breakers protect the DC charging circuit from the batteries to
the charger. The internal fuses in the charger protect the DC charging circuit from the charger
to the batteries. The circuit breakers can be tested by pressing the red button on the breaker. This
will trip the breaker and deactivate the circuit. Reset the breaker by raising the lever at the center
of the breaker until it locks in the horizontal position.
Outlets
Supply electrical current to the cabin ground fault interrupter (GFI) electrical outlets.
Note: All AC electrical outlets are provided with ground fault interrupters to protect
against electric shock. These outlets should be tested periodically to ensure proper
operation by pressing the test/reset buttons in the center of face plate. GFI outlets
do not protect against short circuits and overloads. This is done by the outlet
breakers on the AC panel.
4-12