PURSUIT 3000 EXPRESS, Руководство пользователя

Страница: 125 / 160

3000 EXPRESS
14-7
Clean the aluminum frame with soap and water and dry thoroughly. Apply an aluminum metal
protector to the entire frame to reduce corrosion and pitting.
Special Notes Prior To Winter Storage
If the boat will be in outside storage, properly support a storage cover and secure it over the boat.
It is best to have a frame built over the boat to support the canvas. It should be a few inches wider
than the boat so the canvas will clear the rails and allow passage of air. If this cover is fastened
too tightly there will be inadequate ventilation and this can lead to mildew, moisture accumula-
tion, etc. It is essential to fasten the canvas down securely so that the wind cannot remove it or
cause chafing of the hull superstructure. Do not store the boat in a damp storage enclosure.
Excessive dampness can cause electrical problems, corrosion, and excessive mildew.
Whenever possible, do not use the bimini top or convertible top canvas in place of the winter
storage cover. The life of these canvases may be significantly shortened if exposed to harsh
weather elements for long periods.
PLACING AN ELECTRIC OR FUEL BURNING HEATING UNIT IN THE BILGE AREA
CAN BE POTENTIALLY HAZARDOUS AND IS NOT RECOMMENDED.
Proper storage is very important to prevent serious damage to the boat. If the boat is to be stored
indoors, make sure the building has enough ventilation. It is very important that there is enough
ventilation both inside the boat and around the boat.
Note: If the boat is to be stored indoors or outdoors, open all drawers, clothes lockers,
cabinets, and doors a little. If possible, remove the upholstery, mattresses,
clothing, and rugs. Then hang a commercially available mildew protector in the
cabin.
14.3 Recommissioning
DO NOT OPERATE THE BOAT UNLESS IT IS COMPLETELY ASSEMBLED. KEEP
ALL FASTENERS TIGHT. KEEP ADJUSTMENTS ACCORDING TO SPECIFICA-
TIONS.
Note: It is important and recommended that the fitting out procedure for the marine
gear be done by a qualified service person. Read the engine owner’s manual for
the recommended procedure.