PURSUIT 3000 EXPRESS, Руководство пользователя

Страница: 80 / 160

3000 EXPRESS
Cockpit Shower
A freshwater shower is located behind a small door in the cockpit. It is supplied hot and cold
water by the freshwater system and works much like the shower in the head.
Stern Seat
A recessed fold down seat is built into the rear of
the cockpit. To use the seat, release the latches by
pulling sharply on the lower edge of the seat.
Then pull the strap at the bottom of the seat
toward the cockpit. The seat will move into the
proper position as it slides out from the stored
position. Make sure the rear of the seat locks into
the slot in the center of the recess. To store the
seat, pull the seat forward and simultaneously
push the front down and toward the rear of the
cockpit. This will cause the seat to fold into the
recess in the rear of the cockpit. To secure the seat
in the stored position, make sure the male studs on
the seat line up properly with the female sockets
mounted on the rear of the recess for the seat.
Secure the seat with a sharp push to snap the studs
into the sockets.
Helm Seat (PEDESTAL)
The helm seat is a pedestal seat that swivels and adjusts fore and aft. There are two levers and
one tension knob on the seat base. Lifting the lever located at the front of the seat base allows
the seat to be adjusted fore and aft. Releasing the lever locks the seat in that position. Lifting
the lever on the port side of the seat base releases the pivot lock and allows the helm seat to be
swiveled on the pedestal. The helm seat will automatically lock when it is swiveled back to the
operating position. The friction knob adjusts the tension of seat base on the pedestal and is also
located on the port side of the seat. It should be adjusted to allow the seat to be swiveled when
the swivel lock is released and tight enough to eliminate play between the seat base and the
pedestal.
Helm
The helm and engine controls are located on an opening helm station. The helm station is hinged
at the bottom and opens to provide access to service the helm equipment or to install electronics.
To open the helm station, slide the helm seat back as far as it will go and release the special clamps
at the top of the helm. A strap holds the helm in the open position and prevents it from opening
too far. Always make sure the helm station clamps are properly secured when the helm is closed.
Stern Seat
9-6