PURSUIT 3000 EXPRESS, Руководство пользователя

Страница: 82 / 160

3000 EXPRESS
To install the Bimini top, attach the main legs to the deck hinges using the quick release pins and
attach the rear of the bimini canvas to the radar arch. Next, open the bimini and attach the front
bows to the deck hinges on the top of the windshield frame. Use your body weight on the front
corner of the bimini to pull down and stretch the fabric until the eye on the bow lines up with the
hole in the deck hinge. Secure each eye to the deck hinge with the quick release pins. The bimini
canvas should be stretched tight when both sides of the front bow are secured to the windshield
frame.
Attach the clear connector to the zipper at the front of the top and snap it to the brow and the top
of the windshield frame beginning with the center snaps. If the bimini top is adjusted properly,
the clear connector will have to be stretched just enough to pull out the wrinkles and reach the
snaps on the windshield. The front bow will continue to bear the main load of the top.
Once the clear connector is completely installed, the side curtains can be put on. Attach the side
curtains to the zippers on the sides of the bimini and to the front connector. Snap the curtains to
the windshield, deck and outboard snaps on the arch beginning with the forward snaps on the
windshield. If the bimini is adjusted properly, the side curtains will have to be stretched slightly
to pull out the wrinkles and reach the snaps. The main load for the top should remain on the front
bows and the arch.
If you have the optional drop curtain, attach it to the arch near the back of the top and to the inboard
snaps on the arch. Snap the drop curtain to the deck and cockpit.
Hard Top
The optional hard top consists of a laminated fiberglass top mounted to a welded aluminum frame
that is bolted to the deck. It is designed to accommodate radio antennas, radar antennas and
navigation lights. It could also be equipped with optional top gun outriggers and/or rod holders.
The hard top is not designed to support the additional weight of items like an instrument locker,
life raft or helm station. Radar and electronics antennas must be mounted to the top between the
front and rear legs. Do not mount any antennas or equipment to the brow area forward of the
front legs. The hard top frame is not designed to support the weight of accessories in this area
and could be damaged. The starboard rear leg is the wire chase for lights and antennas mounted
to the top. Because the aluminum frames vary slightly, the side curtains, front clear connector
and drop curtain are custom made to each boat at the factory.
Hardtop Canvas Installation
Front Connector and Side Curtains
1. Slide front connector canvas piece into track on the hardtop.
2. Snap the port side corner center snap of the connector.
3. Stretch connector to the starboard side and snap the center snap on the starboard side.
4. Slide both side curtains onto the hardtop track and zip to front connector.
5. Stretch the side curtains toward the back of the boat. Snap the top snap on the rear hardtop
leg.
6. Snap all the remaining snaps on the front connector and side curtains.
9-8