PTI security systems Wireless Door Alarm System, Инструкция по установке и эксплуатации

Страница: 65 / 84

60 rev. 7-2017 114A3873.D
Wireless Door Alarm System
Test the door transmitters
Slide a thin piece of ferrous metal between the magnet
and the transmitter housing - an electrical junction box
cover works very well.
Make sure that the metal used is not copper, brass, or alu-
minum. A magnet must stick to the metal for it to work.
To test the doors, slip the metal plate between the magnet
and the transmitter housing. Hold it in position for two to three
seconds, then remove it.
If the door transmitter is working properly, the controller will
show a
Door Open
or
Door Alarm
event followed by a
Door Close
event and a reference to the unit number.
If the controller does not show any activity, check the
transmitter installation carefully.
If the controller shows an
Unknown Door Open
and an
Unknown Door Close
, the door table reference is wrong in
the controller.
(The door table may not have been downloaded)
If the door table is right, the correct unit number will appear. If
not, the door table needs to be updated or the system will not
operate properly.