PTI security systems Wireless Door Alarm System, Инструкция по установке и эксплуатации

Страница: 41 / 84

36 rev. 7-2017 114A3873.D
Wireless Door Alarm System
Tamper Sensor Enable/Disable
Tamper Sensor is:
ENABLED
Press
*
to Change,
PRESS # WHEN DONE
The Tamper Sensor parameter enables/disables the tamper switch.
When
ENABLED
, the multiplexer will send a tamper alarm to the
controller if the door to the multiplexer is opened. When
DISABLED
,
the tamper sensor is ignored.
This only affects the tamper sensor on the multiplexer case .
It does not enable or disable tamper alarms from the wireless
transmitters. The factory default is
ENABLED
.
Beep with Key Press
Beep with Key Press controls the buzzer on the system. When set to
YES
, the multiplexer will produce a very short beep when a key is
pressed. Installers have an additional signal to verify entries from
the keypad. The factory default is
YES
.
Beep with Key Press?
YES
Press
*
to Change,
PRESS # WHEN DONE
Date Format
Date Format:
US
Press
*
to Change,
PRESS # WHEN DONE
The Date Format parameter controls the format of the date shown
on the display. It does not affect the date or time from the controller.
The options are
US
format and
EUROPEAN
format. The factory
default is
US
.