PTI security systems Wireless Door Alarm System, Инструкция по установке и эксплуатации

Страница: 37 / 84

32 rev. 7-2017 114A3873.D
Wireless Door Alarm System
Displaying the Multiplexer
Address and ID
To display the multiplexer address and ID, press the * key on the
multiplexer until the display shows “
DISPLAY UNIT ID?
”, then
press the
#
key. The display will then show the part number of the
multiplexer, the address it is set for, and the serial number of the
device. The display will be similar to:
Line one
the part number of the multiplexer and the
firmware revision.
Line two
the address of the multiplexer on the RS485
communication line. This address is used by the
controller to communicate with the multiplexer.
It must be unique and not shared by any other
device attached to the system.
Line three
and four
the serial number of the multiplexer and the
manufacturing date code
This is the easiest way of checking the address of the device. This
display will also show for a few seconds when the multiplexer is first
connected to power.
AXWM400AAO 1.10
UNIT ADDRESS: 05
UNIT SERIAL NUMBER
AXWM10001001 020109
1
2
3 & 4