PTI security systems Wireless Door Alarm System, Инструкция по установке и эксплуатации

Страница: 30 / 84

Wireless Door Alarm System
25 114A3873.D rev. 7-2017
There are two different generations of PTI wireless door alarms.
The FA system is the older generation, and is not compatible with
the newer system, the EchoStream system. You cannot mix the two
different styles. When ordering replacement transmitters, make
sure you know which type the site is using.
Locating the Wireless Multiplexer
The wireless multiplexer must be installed in a secure indoor
location, accessible for system programming and maintenance.
Do not install where users can access the unit. The multiplexer
should be installed in an office where general access to the unit is
controlled and within 100 feet of the wireless receiver
Locating the Receiver
It is good practice to mount the receiver close to the multiplexer
it is connected to because every time a device is added to the
programming, a button must be pressed inside the receiver.
If possible, keep the receiver away from large metal objects.
DO NOT install the receiver on a metal surface they impair the
performance of the receiver.
If there is a concern about signals reaching the receiver, a repeater
can be placed high up and close to the receiver, and the signals
can route through it if needed. The repeater does not have to be
accessed for programming and therefore can be placed anywhere.
Do not combine the FA door alarms with the EchoStream
system. They are not compatible.
Make sure you know which type the site uses.
The receiver must be installed in a secure, indoor,
accessible location.
DO NOT mount the receiver high up in the building.