PTI security systems Wireless Door Alarm System, Инструкция по установке и эксплуатации

Страница: 22 / 84

Wireless Door Alarm System
17 114A3873.D rev. 7-2017
Hollow Core Swing Door Header Mounting
Instructions
1 Apply PL Premium
®
construction adhesive to the back of
the magnet. Align the center of the magnet with the narrow
mark on the side of the mounting plate facing the door and
rivet the magnet to the door no more than ½ inch away
from the mounting plate with two screws (type of screw used
to be determined by door type). See page 5 for more
information.
2
Apply PL Premium
®
construction adhesive to the back of the
mounting plate and use two wall anchors and two #8 x 1” flat
head screws to fasten mounting plate.
3 Position the box bottom with the alignment marks facing
toward the door and fasten the wireless box bottom to the
mounting plate using two 6-32 x 3/8” pan head screws.
4
Place the PC board in the box bottom and hold in place until
the box cover is in place (See Drawing 7 on page 18 for
cover positioning).
5 Fasten the box cover to the box bottom using two #6 x 1-½”
flat head screws.
APPLICATION NOTE: Always use PL Premium® adhesive on
both magnet and mounting plate. Box assembly should be
mounted in place on header to prevent damage.