PTI security systems Wireless Door Alarm System, Инструкция по установке и эксплуатации

Страница: 62 / 84

Wireless Door Alarm System
57 114A3873.D rev. 7-2017
Testing the Installation
The wireless door alarm system testing process can usually takes
a few hours to complete for most installations. Testing consists of
four basic diagnostic procedures:
Many door alarm issues need to be checked by a trained
service technician.
Test the link to the controller
Make sure the wireless multiplexer is communicating with the
controller. When properly connected, the controller will report
a
Data Comm. On
event referenced to the multiplexer
address.
Also check the communication is to look at the light emitting
diodes (LEDs) on the wireless multiplexer board
Just below the center of the board there are six LEDs that
indicate the status of communications. These LEDs can be
quickly identified by looking for the reference designators
D1
through
D6
on the board.
(See “Drawing 19: Components to check when
Troubleshooting” on page 5562).
During normal operation, all of the lights should be blinking.
When the multiplexer is not communicating,
D1
and
D4
will be
constantly ON.
If the wireless multiplexer is not communicating, check the
wiring and settings in the controller