Panasonic WJND400 - NETWORK DISK RECORDER, Руководство по эксплуатации

Страница: 120 / 233

Usin g the Front Panel for Operations
51
11
Check the disk information.
Check the follo w ing content related to the HDD under [Disk
information] on the settings menu. Refer to the Setup
Instructions (PDF file) for more information.
• HDD capacity
• HDD remaining capacity
• Hour meter
• Disk operation mode
• Date range of video recorded on the HDD
Note:
• You cannot remove individual HDDs b y opening the front panel
w hile operating in RAID5 or RAID6 mode.
• Refer to page 53 w hen replacing HDDs w ith errors.
Sets the HDD operation mode.
The initial setting is set to [SINGLE mode].
This setting is not necessary to use the single mode as it is set up.
1
Turn off the recorder.
Turn off the po w er according to "Turning Off the Po w er
(page 39)".
2
Turn on any extension units first if any are connected.
3
Insert the key (included) into the key hole and turn it
while pressin
g in g ently to open the front cover.
4
Sets the operation mode with the [RAID] switch.
5
Hold down the [USE] button and turn on the power to
boot up.
• The settings are ena b led at b ootup. Continue to press the
[USE] b utton until the b uzzer sounds.
Settin g the HDD's Operation Mode
S : SINGLE mode (default)
R5 : RAID5 mode
R6 : RAID6 mode
Important:
• The HDD operation mode cannot b e changed once the
system is operating. Recorded data may not b e read correctly
if the mode is changed after the system is operating.
(1)
(2)
[USE] b u tton [RAID] switch
ND400_Basic.book 51 ページ ２００８年７月１０日 木曜日 午前１０時５０分