Panasonic S-200PE1E8, Технические данные и руководство по обслуживанию

Страница: 192 / 197

8 8
4. Accessories
No. Accessories Quantity
1 Receiver
(Enclosed 200 mm wiring)
1
2 1
3 Remote controller's holder 1
4
Remote controller
AAA alkaline batteries 2
No. Accessories Quantity
5 Users Manual 1
6 Truss self-tapping screws
4 × 16
2
7 Machine screws 2
8 2
9
Wood screws
Cable tie 1
5. Installing the Receiver Unit
When using a separately installed receiver as a built-in model, install it to the JIS switch box (field supply)
shown in the diagram on the right, which has been built into the wall on site in advance.
(1) Remove the face plate of the receiver by slipping a
flathead screwdriver or the like into the cutout on the
bottom.
(2) Install the receiver with the 2 enclosed machine
screws (M4).
(3) Connect the receiver’s wiring (2 cores) with the wiring
from the indoor unit. (Refer to the chapter on wiring the
receiver) When wiring receivers, be sure to double-check
the terminal numbers of the indoor unit before connecting
them so there are no mistakes in the wiring. (Damage will
occur if high volt-age [e.g. supply voltage] is applied.)
(4) Attach the face plate.
• W hen using a separately installed receiver as an exposed
model, attach it to a wall where the receiver can be affixed.
(1) Put a flathead screwdriver or the like into the groove on the
bottom of the receiver unit and twist it to remove the bottom
of the case. (Fig. 8-2)
(2) To enable the receiver’s wiring to stick out from the upper
part of the case (thin part at center-top), use side-cutters or
the like to cut a hole in the case big enough for the remote
control cord (sold separately). (Fig. 8-3)
(3) Disconnect the wires that were connected at shipment from
the connector.
(4) After installing the remote control cord (sold separately) at
the position in Fig. 8-4 with the enclosed cable tie,
connect it to the connector on the receiver.
(5) Shape the remote control cord at the top of the PCB so it
fits inside the receiver and after configuring the wiring like
it is in Fig. 8-5, attach the lower case. When doing this,
arrange the head of the cable tie so it faces side-ways.
(6) Remove the face plate and use the wood screws (2)
to install the receiver unit.
(7) Use the cord clip that comes enclosed with the
remote control cord to fasten it to the wall.
(8) Attach the face plate.
About 2 to 3 mm
Fig. 8-2
Fig. 8-3
Fig. 8-4
Fig. 8-5
M4 × 25
Machine screws (2)
Receiver Unit
Spacers
Cutout
Face Plate
Single outlet switch box
(no cover)
Outlet in the upper part of the
case for the remote control cord
Cable tie (Enclosed)
Connector Remote control cord
(Sold separately)
Remote control cord
(Sold separately)
Cable tie
(Enclosed)
Wood screws
(2)
Receiver unit
Fig. 8-1
8-12
SM830194-04_Single_BigPAC.indb 12 2014/10/31 13:30:52