No. SX-DSV03224-62-
R6.0
Motion Control Business Unit, Panasonic Corporation
Procedure of connection to the power connector
To connect to Connector XA XB XC XD , follow the procedure below.
＜
Wiring method
＞
1. Stripping electric wires to be used. Please refer to the figure below for the strip length
8～9 mm
2.Insert the wire into the connector.
①
Push down the spring by
pushing the control lever
attached to the upper
operating slot with your
fingers.
②
Insert the wire while
pressing the control lever.
Please be careful that all
strands are inserted into the
spring opening
③
You can wire it by
releasing the control lever.
Please pull the wire lightly
and make sure that the wire is
securely connected.
<Notes>
· Be careful not to damage the core wire or cut it when stripping the wire.
· Because the strip length of the electric wire depends on the size and type of electric wire,
please decide the optimum strip length according to the processing condition.
· For wiring, please disconnect the connector from the servo driver main body.
· Insert one wire into one wire insertion slot of the connector.
· When the control lever is pushed down, the wire can be removed.
10 mm (Size A
-
C , Size D 200 V
XA XB
)
11 mm (Size D 400 V, Size E
XA XB XC
)
8 mm (Size D
-
E 400 V
XD
)
