Introduction: Control Reference Guide
23
Intr
od
uc
tio
n
5.
SUPER switch
Switches the super output as follows.
6.
REC INH switch
Select to enable or disable recording to P2 cards.
7.
STOP switch
Press to select signals in stop mode.
8.
TC PRESET button
Set the TC or UB value. To make a setting, first press
this button to change the flashing digits.
Note that this button is not available in thumbnail
mode, USB device mode, LAN mode and browser
mode.
9.
RESET/NEW button
RESET button
Press this button when the LCD panel counter is in the
CTL mode to reset the counter display to [0:00:00:00].
Hold down the TC PRESET button and press this
button when the LCD panel counter is in the TC mode
(read time code) or UB mode (user bit of the read time
code) to reset the time code generator.
When using the on-screen keyboard, use this button to
delete all text, IN/OUT points in playlists, etc.
NEW (SHIFT + RESET) button
Use these buttons in the playlist.
➝
Refer to “Creating a New Playlist” (page 96).
10.
COUNTER button
Press to switch the counter display of the LCD panel.
Each press of this button changes the counter display
as follows: [CTL (relative position from the beginning)]
➝
[TC (read time code)]
➝
[UB (user bit of the read
time code)].
11.
SEARCH button
Press this button to engage the search mode. Set the
search dial to the SHTL mode, turn it to the desired
position and press this button to start playback at the
speed set with the search dial.
12.
Search dial
Use to search and check video. Each time you press
the dial, the SHTL (Shuttle)/SLOW mode and the JOG
mode are engaged alternatively. The respective
indicator lamp lights. When the power is turned on, the
search dial will not operate unless it is first returned to
the STILL position.
13.
SHTL/SLOW button
Press this button when the search dial is in SHTL
(shuttle)/SLOW mode to toggle between SHTL (shuttle)
and SLOW modes.
14.
TEXT MEMO/MARKER button
TEXT MEMO button
Press this button during recording and playback
where you wish to enter a text memo. In the thumbnail
screen, press this button to add a text memo to a clip
thumbnail (normally at the start of a clip).
➝
Refer to “Attaching Text Memos” (page 64).
MARKER (SHIFT + TEXT MEMO) button
In the thumbnail screen, hold down the SHIFT button
and press this button to turn the marker of the clip at
the pointer position on and off.
➝
For details, refer to “Attaching Shot Marks” (page
65).
15.
CLIP SELECT button
Press this button to play back video clip by clip.
➝
For details, refer to “Clip Select Function” (page
157).
EXT:
Uses the external time code input from the
TIME CODE IN connector or VITC, SLTC or
SVITC video input signals.
Select in setup menu No. 507 (EXT TC
SEL).
ON:
Outputs superimposed data such as time
codes to the LCD monitor, SD SDI MON
connector or the ANALOG VIDEO MON
connector.
OFF:
Does not output any superimposed information.
ON:
The REC INH lamp on the display panel
lights indicating that recording is disabled.
OFF:
Turns off the REC INH function to enable P2
card recording.
PB:
Outputs signals played back from a P2 card.
EE:
Outputs input signals selected with the
VIDEO IN (SHIFT + EDIT MODE) / AUDIO IN
(SHIFT + VIDEO) buttons.
