Editing: Creating Playlists
101
Ed
it
in
g
1
Switch to player or recorder operation.
Press the PLAYER button to switch to player or recorder
operation.
2
Use the GOTO button and the IN or OUT button to
find the IN or OUT point.
Hold down the IN or OUT button and press the GOTO
button to move the playback location to the IN or OUT
point.
3
Set the IN or OUT point of the player or recorder.
While looking at the player or recorder screen, hold down
the IN or OUT button and press the ENTRY button to set
the IN or OUT point again. Or hold down the IN or OUT
button and press the RESET button to cancel the IN or
OUT point.
4
Move the IN or OUT point of the player or recorder as
necessary.
To fine adjust, hold down the IN or OUT button and press
the TRIM+ or TRIM– button to move the IN or OUT point.
Hold down the button for 1 second or more to make
continuous settings.
After setting the IN or OUT point, preview to check edit result
on the recorder.
1
Press the PREVIEW button to preview.
Start preview by pressing the PREVIEW button to play
back the edited section on the recorder starting 3 seconds
before the beginning of the edit section (PREROLL TIME
setting) to 1 second beyond the end of the section.
2
The result is assigned as events to the timeline.
◆
NOTE:
• To end preview, press the STOP button.
• The audio level for each event can be separately set during
preview.
➝
Refer to “Setting Audio Level” (page 114).
• To confirm the edit result without previewing it, press the REC
button.
• Setting the OUT point for the recorder during preview stops
preview and newly starts editing with the set OUT point.
• When only the IN points for the player and the recorder are set,
you can edit up to the end of the player clip, which becomes the
OUT point for the player.
• When no other operation has been performed after confirming
an edit, a second preview will play back the section edited
immediately before. The audio level for this section can then be
adjusted. This level is cancelled if an IN or OUT point is set or
event operations are performed.
Revising IN and OUT points for the player
and recorder
3
1
2
2,3,4
3
4
Preview and assigning events (when the
player is a P2 card)
1
