Page
48
of
248
ATE0Q1&W
Press ENTER
After the modem has been dumbed down by these commands it will not even say 'OK' to an AT command
anymore. To see if it's still working you may try a command with a non-simple response such as AT&V
To configure XLink to answer at 115200, USB connect with LinkComm, use the Diagnostics, Terminal
window. Press ENTER to get the ">" prompt and issue the following:
RS232 Baud Rate=115200
Then reboot the unit for the new baud rate to take effect by issuing the Reboot command or power
cycling the unit.
The modem will now automatically answer calls and provide remote communications.
See section
for instructions on how to use LinkComm with the
external modem.
5.26
Connecting External Cell Modems
You can connect an external cell modem for remote communication via LinkComm or other
communication programs. The following details show how to do this using Sutron’s GPRS
-1-O modem that
is preconfigured to operate as a client serial bridge to accept connections and pass data between XLink
and the remote caller. The modem will connect to the RS-232 port via a male-male null modem cable.
Follow these steps to configure the GPRS-1-O modem to operate in serial bridge mode.
1) Creating/selecting the script. Some readymade scripts are provided based on typical settings and
common APNs. Go ahead and use ATT_script.txt, T-Mobile_script.txt, or Rogers_script.txt if you are using
either of these providers. Otherwise, contact Sutron for help in creating the proper files for the modem.
2) Load the script into a thumb drive. The file must be copied into the station folder and must be renamed
with the station as part of the file name. For instance, if the station was named S01, then the file must be
renamed "S01_script.txt"
3) Attach the modem to the RS-232 port and insert the thumb drive. Look for a script_results.txt in the
daily sub-folder and examine it for errors. Once the modem is working, enable passwords to help secure
the station.
The script is designed to be run on a factory fresh modem or one that's already running the script. The
script will switch the speed of the RS-232 port to 115200 baud.
See section
for instructions on how to use LinkComm with the external
modem.
Содержание SUTRON XLINK 100
Страница 1: ...Operations Maintenance Manual SUTRON XLINK 100 500 Part No 8800 1217 Rev 8 44 4 January 14 2022...
Страница 230: ...Page 230 of 248...
Страница 247: ...Page 247 of 248...
