OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 90 / 98

3. Remove the wing-nut that holds the Ground Strap to the Ground Post on the enclosure. Remove that
end of the strap.
4. Pull the Door Assembly straight up until the hinges are disconnected. Take the Door Assembly indoors
and put it on a flat surface with the board side up.
5. Pull off all of the rubber gasket material that is currently on the door assembly. Make sure to remove all
remaining adhesive.
6. The Gasket Upgrade Kit contains 4 lengths of new rubber gasket to be installed:
l
one (1) piece, 13.25 inches
l
one (1) piece, 14 inches
l
two (2) pieces, 17 inches
NOTICE: DO NOT stretch these rubber pieces when you install them. They are cut to the
exact lengths necessary. If stretched, they will not provide a sufficient seal to keep water
out of the unit.
Doc. No.: M1010 Rev.: 10
Page 90 of 98