OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 31 / 98

3. Install the Data Cable (20-1679).
a. Verify that the Micro-RS232 connector end is connected to the data port on the top of the
printer unit.
b. Attach the RJ-45 connector end to the J10 Printer Comm port on the main board.
4. Install the Power Cable (20-1721).
a. Verify that the small connector end of the cable is connected to the power cable port on the top
of the printer unit. Make sure the locking tab of the connector points toward the rear of the unit
(the side where the paper is loaded).
b. Attach the large 2x3 Pin Molex connector to the J14 Printer Power Port on the main board.
7.2 Load Receipt Printer Paper
The receipt printer accepts metric-sized thermal paper 58 mm (2.28 in.) or 60 mm (2.36 in.) width and 102
mm (4 inches) in diameter.
Doc. No.: M1010 Rev.: 10
Page 31 of 98