OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 72 / 98

Install the VIS Controller Assembly
1. Remove the nuts from the studs on the back wall of the PV200 enclosure where the VIS Controller
Assembly is to be installed.
2. Attach the four (4) standoffs (50-0443) to the studs.
3. Hold the VIS Board Assembly (20-0415-XX) on the standoffs as shown above.
4. Put the four (4) screws through the holes in the VIS assembly and attach them to the standoffs.
5. Connect the 20-1732 AVI Petro-Net Cable to one of the three Molex connectors (J6/J7/J8) of the
Petro-Net Power Hub Board (20-0414).
6. Connect the Yellow, Violet, Black and Red terminal wires of the 20-1732 cable to the J1 Terminal Block
of the VIS Board Assembly as shown in the illustration above.
Install the Antenna
For information on the installation of the recommended antenna types (Body Mount or Panel style) refer to
M1040-ANT AVI Antenna Installation.
Doc. No.: M1010 Rev.: 10
Page 72 of 98