2. Mark the four (4) most applicable locations for the anchor bolts. There are eight (8) bolt holes (see the
illustrations above).
3. Drill the holes.
4. Anchor the pedestal with 3/8” anchor bolts.
IMPORTANT:
Use a type of anchor bolt that is appropriate for the material in which you will
anchor the pedestal (e.g. concrete).
5. Use the provided hardware to attach the enclosure to the pedestal. Align the provided gasket with the
mounting holes of the pedestal top plate. Carefully position the enclosure in place so that the open
installation holes are aligned with the installation holes of the pedestal (see the illustration above). Put
the four (4) bolts through the holes and tighten them using the provided washers and nuts.
Doc. No.: M1010 Rev.: 10
Page 19 of 98
Содержание Petro Vend 200 M1010
