OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию, Страница: 66 / 98

Install the Dual Mag Reader PCB
The 20-0417 Dual Mag Reader PCB will be installed on top of the PV200 LED Light Board. See the photo at
the top of this instruction for the location of the LED board.
12. Loosen and remove the two (2) 50-0005 nuts from the sides of the LED Light Board.
13. Align the holes of the 20-0417 PCB with the threaded posts where the nuts were removed.
14. Install the two (2) 50-0005 nuts back onto the threaded posts.
15. Make the cable connections as follows:
l
Right Reader: The 7-Pin connector end of the 20-1642 cable was connected to the reader in step 9
above. Connect the 10-Pin connector end of the 20-1642 Cable Assembly to the J3 connector of
the Dual Mag Reader PCB as shown above.
l
Left Reader: The 7-Pin connector end of the 20-1642 cable was connected to the reader in step 9
above. Connect the 10-Pin connector end of the 20-1642 Cable Assembly to the J1 connector of
the Dual Mag Reader PCB as shown above.
l
Connect one of the 10-Pin connector ends of the 20-1698 Connection Cable to the J2 connector of
the Dual Mag Reader PCB as shown above.
l
Connect the opposite 10-Pin connector end of the 20-1698 Connection Cable to the J13 connector
of the PV200 Main Board as shown above.
Doc. No.: M1010 Rev.: 10
Page 66 of 98