OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 60 / 98

6. Put the front of the Card Reader (75-3022) through the open position slot until the frame is flush with
the back of the pocket.
7. Put the bracket over the four (4) screws of the pocket position.
8. Put the four (4) nuts (50-0005) on the screws and turn them clockwise with a 5/16” socket or nut driver
until they are tight.
9. Plug the 7 position connector of the wire harness (20-1642) into the connector on the top of the Mag
Reader unit (75-3022-1) (B-B).
10. Push the LED light of the wire harness (20-1642) into the LED Clip assembly.
IMPORTANT: If this Card Reader kit is installed as part of a Dual Card Reader upgrade, do
not do step 11. See "Dual Magnetic Card Reader Installation" on the next page for connection
instructions with two (2) readers.
11. Plug the 10 position connector of the wire harness (20-1642) into the J13 connector of the Main Board
(A-A).
Doc. No.: M1010 Rev.: 10
Page 60 of 98