OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 91 / 98

7. Remove the plastic strip from the back of the 14 inch piece to expose the adhesive. Start at one side of
the top slot of the door assembly. With the adhesive face down, carefully push down all the way across
the gasket in the slot to install the 14 inch piece as shown in the photo above. Make sure you do not
stretch the gasket.
8. Remove the plastic strip from the back of one of the 17 inch pieces to expose the adhesive. With the
adhesive face down, start at the top left corner and start the installation of this piece up against the 14
inch piece and against the edge of the door frame as shown. Carefully push down all the way along the
gasket against the edge of the door frame to install the 17 inch piece. Make sure you do not stretch the
gasket.
IMPORTANT: This 17 inch piece will have a slight gap at the bottom as shown in the photo
above. DO NOT TRY TO STRETCH THIS GASKET TO THE BOTTOM!
9. Do the same procedure as Step 8 for the other 17 inch piece and install it from the top right corner.
Make sure you do not stretch the gasket.
10. Remove the plastic strip from the back of the 13.25 inch piece to expose the adhesive. With the
adhesive face down, start at the left and start the installation of this piece up against the 17 inch piece
on the left and against the top edge of the slot as shown. Carefully push down all the way along the
Doc. No.: M1010 Rev.: 10
Page 91 of 98